First Cold Snap? Furnace Repair in Post Falls, ID

  • Post Falls Furnace, Heat Pump and AC Repair
  • 24/7 Emergency No-Heat Repair

Gas Furnaces · Electric Furnaces · Heat Pumps · Dual Fuel · Central Air · Mini Splits

Furnace and Heating Repair in Post Falls, ID

Gas furnace and electric furnace repair, and heating repair, across Post Falls and Kootenai County.

Call (208) 586-9769
Gas furnace repair in Post Falls, ID, basement furnace with metal supply and return ducts beside a tank water heater

Gas and Electric Furnace Repair in Post Falls, ID

Furnace and heating repair in Post Falls, ID covers the forced-air gas furnaces in most houses, whether the unit sits in a utility closet, garage or basement, plus the electric furnaces and heat pump air handlers in the rest. We repair both kinds, from 80 percent furnaces vented through a metal flue to 90 percent and higher condensing furnaces vented through white PVC pipe out the side wall or roof.

A furnace that stops heating has almost always lost one part in a chain. Furnace repair covers these parts:

  • Hot surface igniters and spark igniters that crack or stop glowing
  • Flame sensors coated with residue, so the burners light and shut off a few seconds later
  • Inducer (draft) motors that hum, rattle or will not start
  • Pressure switches and the small rubber hoses and ports that feed them
  • Gas valves on furnaces that light poorly or not at all
  • Blower motors, run capacitors, variable speed motor modules and dirty blower wheels
  • Limit switches and flame rollout switches after an overheat
  • Circuit boards, 24-volt transformers, blower door safety switches and thermostat wire
  • Condensate traps, drain lines and pumps on high efficiency furnaces
  • Heating elements, sequencers and relays in electric furnaces

Why North Idaho Winters Wear Out Furnace Parts

The heating season runs from mid-October into late April. Igniters crack after thousands of cycles, inducer and blower motor bearings wear, and filters load up faster through a long winter. A clogged filter cuts airflow, the heat exchanger runs hot and the high limit switch shuts the burners off. Those wear parts are the usual cause of a furnace that quits in December or January, not the furnace as a whole.

Furnace Service for Newer Post Falls Homes

High efficiency furnaces with electronic controls fail differently from older ones: a flame sensor or pressure switch fault, a condensate trap that plugs, a cracked PVC fitting, or a control board that lost a relay. Their intake and exhaust pipes leave the house near ground level, where drifting snow can bury them and shut the furnace down.

Older homes in Dalton Gardens and near downtown Coeur d'Alene are a different job. Many still have 80 percent furnaces on original ductwork and metal flues, where a dirty blower, an undersized return or a worn draft inducer is more likely than a control fault.

Furnace Repair in Post Falls or Replacement

Most furnace failures are single parts, and a furnace in sound condition is worth repairing. Replacement comes up when the heat exchanger is cracked, when the same major part keeps failing, or when parts for an old furnace are no longer made. When the furnace and an air conditioner are both near the end, matching them as one system is worth considering. For the outdoor side of the system, see AC repair in Post Falls and heat pump repair. If the furnace is out in freezing weather, see emergency furnace repair.

If the furnace runs but the house stays cold, see furnace blowing cold air repair in Post Falls. For annual service, see furnace tune-up in Post Falls.

Taking Care of Post Falls Furnaces, Heat Pumps and AC in 22 Tune-Up Points

The 22 points below are what a full heating and cooling tune-up in Post Falls, ID covers, grouped by system. See furnace tune-up in Post Falls and furnace and heating repair in Post Falls for more on each one.

Furnaces

  1. Check the igniter or pilot and the flame sensor
  2. Check the pressure switch, inducer and flue connection
  3. Inspect the heat exchanger and burner flame
  4. Check the blower motor, capacitor and air filter
  5. Clear the condensate trap and drain on condensing furnaces
  6. Check PVC intake and exhaust pipes for snow, ice or debris
  7. Test the limit switch, rollout switch and door switch
  8. Check the gas valve, manifold pressure and burner ignition
  9. Check thermostat operation and low-voltage wiring

Heat Pumps

  1. Check defrost operation and the outdoor coil
  2. Test the reversing valve and defrost sensors
  3. Check backup heat strips or the paired gas furnace
  4. Clear snow and debris from around the outdoor unit
  5. Test run capacitors, contactors and the outdoor fan
  6. Check the outdoor unit pad, level and electrical disconnect

AC and Mini Splits

  1. Clean condenser and evaporator coils
  2. Test run capacitors and contactors
  3. Flush condensate drains, pans and pumps
  4. Check refrigerant circuit performance
  5. Clean filters, blower wheels and mini split heads
  6. Check line-set insulation and the outdoor disconnect
  7. Check filters loaded by summer dust and wildfire smoke

We cover Post Falls and the towns around it, including Hayden, Rathdrum and Spirit Lake. The full list is on the service area page.

Furnace and Heating Repair Questions in Post Falls, ID

What are the signs that my furnace is going bad?

Short cycling, burners that light and then shut off, cold air from the vents during a heat call, new rattles, squeals or booming at ignition, a blower that runs nonstop, and rooms that never reach the set temperature. Error codes flashing on the control board light are also a sign. Any one of these points to a specific part rather than a furnace at the end of its life.

Why is my furnace running but not heating?

If the blower runs but the burners never light, the cause is in the ignition sequence: the inducer motor, the pressure switch, the igniter or the gas valve. If the burners light and then go out after a few seconds, the flame sensor usually needs cleaning or replacing. A clogged filter can also overheat the furnace so it shuts the burners off on its high limit switch while the blower keeps running.

Why is my furnace blowing cool air when the heat is on?

Check that the thermostat fan is set to Auto, not On. If it is on Auto, the furnace has likely locked out after failed ignition attempts or tripped its limit switch, so the blower moves air through a cold heat exchanger. On high efficiency furnaces, a frozen or plugged condensate line or a blocked PVC vent can stop ignition the same way, which is common after heavy snow.

Why does my furnace keep turning itself off?

A furnace that shuts off early is protecting itself. The usual causes are a dirty flame sensor, a clogged filter or closed vents tripping the high limit switch, a pressure switch that loses its signal, or a thermostat mounted where it heats up faster than the rest of the house. The control board light usually blinks a code that points to which one.

What are the symptoms of a bad blower motor in a furnace?

Humming without the blower turning, a burning smell at startup, squealing or grinding, weak airflow at every vent, or a blower that starts and stops on its own. On furnaces with an older PSC motor the run capacitor often fails first; on newer furnaces the variable speed motor module can fail on its own.

What would cause a furnace to not shut off?

If the burners keep firing after the house is warm, the thermostat or its wiring is still calling for heat, or the gas valve is sticking open. If only the blower keeps running, the fan may be set to On, the limit switch may be holding the blower on after an overheat, or a relay on the control board may be stuck.

Why is my furnace suddenly making a lot of noise?

A loud boom at startup points to delayed ignition from dirty burners. Squealing comes from a worn blower motor bearing or belt. Rattling is often a loose panel or a failing inducer motor. A steady hum with no airflow is usually a capacitor or a seized motor. Each noise points to one part.

How do I know if my furnace needs to be replaced?

A cracked heat exchanger, the same major part failing again and again, rust through the cabinet, or a furnace so old that parts are no longer made are the usual reasons. Most other failures are single parts. The decision comes down to the furnace's condition and the size of the repair.

Furnace, Heat Pump and AC Brands We Repair in Post Falls, ID

  • Carrier
  • Trane
  • Lennox
  • Rheem
  • Goodman
  • York
  • Bryant
  • American Standard
  • Ruud
  • Amana
  • Payne
  • Coleman
  • Heil
  • Tempstar
  • Maytag
  • Mitsubishi
  • Fujitsu
  • Daikin
  • LG
  • Samsung
  • Bosch

Furnace and heating repair in Post Falls, ID on Carrier, Trane, Lennox, Rheem, Goodman, York, Bryant, American Standard, Ruud, Amana, Payne, Coleman, Heil, Tempstar and Maytag furnaces. AC, heat pump and mini split repair in Post Falls, ID on those same central brands plus Mitsubishi, Fujitsu, Daikin, LG, Samsung and Bosch ductless systems.

We Love Serving Post Falls, ID

Frontier HVAC Repair works on the furnaces, heat pumps and air conditioners of Post Falls from Prairie Falls and Tullamore to Treaty Rock and the Highlands, and in nearby Coeur d'Alene, Hayden, Rathdrum, Dalton Gardens and Spirit Lake. Nobody in Post Falls should sit through a cold night with the heat out, or a hot, smoky afternoon with the AC down. Call us at (208) 586-9769.

Call (208) 586-9769